Fairly new to Qualys, so I hope this isn't too basic, but I can't find a specific answer to my issue anywhere.
I'm trying to improve my Qualys map scans by adding a defined list of approved asset hosts. I was hoping to do this by using dynamic asset tags, however, when I go to add an asset tag to the approved asset host list (next to "configure" in the edit section of the domain in question), I am able to find the asset tag, but unable to select it. It's greyed out as though I am unable to choose it for some reason, but I can't figure out how that is.
For the record, I know I could put in just the block of IP addresses, but I don't want to go down this route as I feel doing it by asset tag should be more reliable and secure.
Any help would be greatly appreciated.