I seem to have overlooked soemthing which I'm sure is quite simple, yet I can't figure it out:
I want to run a report based on the results of a scan from two months ago.
The scan itself contains over 100 IPs and is subsequently thousands of pages long.
I want to run and view the results for a single specific IP from the report.
I cannot seem to find a way to do this.
The way I envision it, once the search list/template were created, I would go to:
1. Reports > New > Scan Report
2. Choose the pertinant report details
3. Specify IP in Report Source section
4. Select Scan Results to pull info from
5. Run report
Anyone know of a way to do this using the standard WebUI?
Thanks in advance,