(KB) Network error 06: LAN has no IPv4 address

Document created by Saxxon McCarty on Jun 10, 2016
Version 1Show Document
  • View in full screen mode

Problem(s)

  1. The DHCP option is selected for the virtual scanner, but the scanner has been moved to another network that it was not originally configured on.
  2. There has not been an IP manually configured if the DHCP option is not preferred.

Resolution(s)

  1. Press ENTER to acknowledge the error message.
    Select Set up network (LAN) > Renew DHCP on LAN, and type "Y" for yes.
  2. Press ENTER to acknowledge the error message.
    Select Set up network (LAN) > Enable static IP config on LAN, fill out all required/network specific IP address information, and select Configure static IP address on LAN, type "Y" for yes.

 

This document was generated from the following discussion: The specified item was not found.

Attachments

    Outcomes