What commands are used on the Cisco command line ?

Document created by kb-author-1 Employee on Jul 15, 2010Last modified by Joe Gregory on May 15, 2015
Version 4Show Document
  • View in full screen mode

Issue:

What commands are used on the Cisco command line when using Unix Auth?


Solution:

The Cisco Authentication tool is part of the Unix Authentication record.

 

The commands used  on the Cisco IOS are:

 

  show version;

  show running-config;          [Requires the ENABLE password]

  show sgbp;

  show ipv6  interface

 

These commands are run as part of QID 45229:

  tclsh

  show snmp group

  show crypto ctcp
  show processes

 

Qualys Support KnowledgeBase

http://community.qualys.com/community/kb

 

ID: 0001.010.613.000

1 person found this helpful

Attachments

    Outcomes